Tube Trimming and Parting Machines
Blade shearing technology for trimming and parting of hydroformed and fabricated tubes.
Applications of Tube Trimming & Parting Machines
- Trim off “Seal Ends” on hydroformed tubes
- Parting of hydroformed tubes
- Trim and part bent tubes to finished lengths
- Angle and miter cuts available
Advantages of Tube Trimming & Parting Machines
- Eliminates fine chips produced by sawing operations
- Less costly than laser
- Faster cycle rates
Tube Trimming & Parting Machine Models
Model 891
Capacity: .188” – 1.50” (4.6 – 38mm) click here for more info
Model 893
Capacity: .50” – 3.50” (12 – 89mm) click here for more info
Model 895
Capacity: 1.0” – 5.0” (25 – 127mm) click here for more info
Call us direct at 912-265-7536 or click here to send us an email
Cutting Capacity
Maximum Tube Size*
Maximum Wall Thickness
Cycle Time
Model 891 Back to top of page
.188” – 1.50” (4.6 – 38mm)
Tubular shapes that fit approximately within a 1.50″ (38.1mm) diameter.
.080″ (Heavier wall option available)
(excluding load/unload) 4-6 seconds
Model 893 Back to top of page
.50” – 3.50” (12 – 89mm)
Tubular shapes that fit approximately within a 3.50″ (89mm) diameter.
.080″ (Heavier wall option available)
(excluding load/unload) 4-6 seconds
Model 895 Back to top of page
1.0” – 5.0” (25 – 127mm)
Tubular shapes that fit approximately within a 5.00″ (127mm) diameter.
.120″ (Heavier wall option available)
(excluding load/unload) 4-6 seconds
*Maximum sizes may vary with shape and corner radius. Haven engineering will review parts for feasibility.
