1 - battery terminal poor contact with low battery 2 - failure battery 3 - Battery electrolyte leak 4 - AC Adapter Anomaly 5 - Dirt on board
<<バッテリー故障>>
# 確認ポイント
バッテリを取り外して充電します。 充電エラー3は起きず他の充電エラーが起きる
# 対処方法
新品のバッテリーに交換しリセットでなおる可能性大
# check point Remove and charge the battery. Charging error 3 does not occur and other charging errors occur
# Action Replace and reset the new battery Reset Operations:DOCK+SPOT button long hold
<<ACアダプター異常の場合、比較的レアケース>>
確認ポイント
ACアダプターの無負荷時のDC出力は正常です。
リセットしても回復しない、基板に異常が見られない場合で
充電エラー3が出るまで数秒かかるならacアダプターを疑って下さい
対処方法
ACアダプターを交換。
DOCK+SPOTボタン長押しでリセット
<< AC Adapter Anomaly ,rare case>> # check point If you check the no-load AC adapter with a multimeter, you will not see any abnormalities. Doubt the AC adapter if it takes a few seconds for the charge error 3 to come out if there is no abnormality on the board that is not recovered after resetting
# Action Replace and reset the AC adapter. Reset Operations:DOCK+SPOT button long hold.
<<基板の汚れの場合、ケース1>>
# 確認ポイント
コイルに毛などが接触。
# 対処方法
基板の付着物をすべて取り除く 本体内部を清掃する 前輪と前輪のセンサーを外して清掃する
<<Dirt on the board corrosion, case 1>> # check point The hair is tangled in the coil.
# Action Removing Trash on the circuit board Cleaning the inside of the roomba body Remove and clean the front and front wheel sensors
<<Dirt on the board corrosion, case 2>> # check point There is no abnormality on the circuit board visually. Measure the Resistance value of r252 (12.4k OHM) with a multimeter. See if the resistance is down to 11k OHM
# Action Dry well by wiping or cleaning the gap of the chips around the r252 of the substrate and the vicinity of the dirt with anhydrous ethanol. R252 's Resistance values will strive to get closer to 12.4 kohm.
<<バッテリー液漏れの場合、ケース1>>
・確認ポイント
充電開始と同時に充電エラー3になる。
本体の充電端子の根元に緑青(銅のサビ)がある。
・対処方法
<<基板の汚れの場合、ケース2>>と同じ
<<Liquid leakage corrosion, case 1>> #check point Charge error 3 at the same time as charging start. There is a patina (copper rust) at the base of the charging terminal of the main body.
#Action Look the "<<Dirt on the board corrosion, case 1>>"
<<Liquid leakage corrosion, case 2>> #check point Check the discoloration of the part. The solder part of c112 and r252 is discolored black.
#Action Replace discolored parts For C112, replace the 1.0 UF 25v ceramic capacity For R252, replace the 12.4k OHM Lack of cleaning around the chip size 1608
R253 or R254 resistance value is less than 0.9 OHM. Circuit board cleaning. If it doesn't improve, give it up